Bevel Back Weatherboard Installation
Timspec CertClad™ Bevel Back Weatherboards
- Bevel Back Weatherboard Installation Kit
- Bevel Back Weatherboard Installation Contractors
- Bevel Back Weatherboard Installation
Installation information. The Bevelback weatherboard System is a traditional timber cladding profile and is formed from steel manufactured in NZ by New Zealand Steel. This steel is available, nationally, branded as Colorsteel® Endura®, Colorsteel® Maxx®, Galvsteel® and Zincalume®. Bevelback Weatherboard is available in two thicknesses: 0.4mm. THE CORRECT WAY TO INSTALL BEVEL-BACK WEATHERBOARDS BY TREVOR PRINGLE, ANZIA, BRANZ PRINCIPAL WRITER wall underlay 32 mm min. Lap 8 × 4 mm weathergrooves to top edge of board to bottom edge of board bevel-back weatherboard insulation wall framing cavity batten single nail per board per stud 10 mm above lower board Figure 1 Bevel-back weatherboards were popular in the 1920s. Metalcraft Bevel Back Weatherboard is a traditional cladding system blending in with modern and traditional design surroundings. Metalcraft Bevel Back Weatherboard is a low cost cladding for out buildings, garages and sheds and is available in Zincalume®, Galvsteel®, Colorsteel® Endura® and Colorsteel® Maxx®.
- Abbreviation
- CMA-CM40010 (Rev 5)
- Version
- Rev 5
- Valid from
- 9/11/2011
- Information provider
- Ministry of Business, Innovation and Employment
- Author
- CertMark International Pty Ltd
- Information type
- Product Certificate (CodeMark)
- Format
Bevel Back Weatherboard Installation Kit
Description
Timber CertClad Bevel Back Weatherboards System to be installed over a cavity in the following range of species:
- Accoya® wood,
- H3.1 or H3.2 treated Radiata Pine,
- Western Red Cedar.
Scope
Scope is according to Timspec CertClad Weatherboards bevelBack Cavity System Installation manual version 1-4 version 2, July 2015 when used as a partial or complete cladding system.
For assistance with locating previous versions, please contact the information provider.
For assistance with locating previous versions, please contact the information provider.
Bevel Back Weatherboard Installation Contractors
This resource is not cited by any other resources.
Bevel Back Weatherboard Installation
Timspec CertClad™ Bevel Back Weatherboards
This document is not CITED BY any other resources:
Timspec CertClad™ Bevel Back Weatherboards
Description
Timber CertClad Bevel Back Weatherboards System to be installed over a cavity in the following range of species:
- Accoya® wood,
- H3.1 or H3.2 treated Radiata Pine,
- Western Red Cedar.
Timspec CertClad™ Bevel Back Weatherboards
Description
Timber CertClad Bevel Back Weatherboards System to be installed over a cavity in the following range of species:
- Accoya® wood,
- H3.1 or H3.2 treated Radiata Pine,
- Western Red Cedar.
Timspec CertClad™ Bevel Back Weatherboards
This resource does not CITE any other resources.